Skip to content
pvvlvz edited this page Nov 11, 2026 · 1 revision

Automatic and manual trains share the track safely.

Following

Every train holds the track under it, plus the distance it needs to stop while moving. A train never enters track another train holds. It brakes and stops half a block behind it, then follows as soon as the train ahead moves off. Standing free coaches hold their track too, so nothing drives through a parked coach.

Single track and passing loops

On single track, two trains heading towards each other would meet nose to nose and both be stuck. Automatic trains avoid that by booking single-track stretches:

  1. Before entering a stretch of single track, an automatic train books it, up to the next junction.
  2. A train coming the other way sees the booking and waits in front of its junction, inside its own passing loop or station, until the stretch is free.
  3. Trains going the same way can still use the stretch together, one following the other.
  4. At a passing loop, oncoming trains take different sides, so they pass each other.
  5. A train standing at a terminus also holds the track behind it, so a train coming in doesn't trap it.
 A ══════════════╦══════════════════╦══════════════ B
                 ╚══════════════════╝
                 J1   passing loop  J2

 Train 1 at A books A→J1. Train 2 at B waits until it can book B→J2.
 They meet in the loop: one takes the straight side, the other the curved side.
 Each then books the next single-track stretch and carries on.

Important

To run trains in both directions on one line, build passing loops. On a line with no loops at all, opposing trains can't pass: they stop a safe distance apart, facing each other, and wait. Trains in the same direction, or lines with separate tracks for each direction, need no loops.


← Signals · Home · Track Cookbook →

Clone this wiki locally