Repository navigation
Troubleshooting
| Check | Fix |
|---|---|
| Is anyone driving? | A manual train only moves with an open throttle. Sit in the locomotive and hold W, or switch it to Automatic. |
| Is the throttle open but the train standing? | It's probably at a red signal (unpowered powered rail), behind another train or a parked coach, or at the end of the track. Look at the message above your hotbar. |
| Did it just stop with "End of the line! Throttle closed."? | The track ends or a junction is set against you. Fix the track or flip the junction, then open the throttle again. |
| Is it an automatic train waiting at a station? | It waits the station's waiting time (up to 120 s). Check the station screen. |
| Does it say "Waiting for the line ahead to clear"? | Another train has booked the single track ahead or is standing on it. See the next table. |
| Is it on a Fabric server with nobody online? | The server is paused. See Chunk loading. |
| Did a coach's chunk fail to load? | The whole train waits until every car is loaded. It goes on by itself once the chunk loads. |
| Is its chunk loading switched off? | Then it waits at the edge of the loaded area until a player comes near. Switch it back on in the train screen. |
| Did a server operator stop it? | Riders would have seen "A server operator stopped this train." It's now in Manual mode: switch it back to Automatic or drive it. |
You're running trains in opposite directions on single track without a passing loop between them. Build a passing loop (see cookbook #3), then switch one train to Manual in the train screen, drive it back into the loop, and switch it back to Automatic. Trains in the same direction never get stuck like this.
- The station must be under the rail or right beside it (same height or one lower), touching the rail block the train runs over.
- With a schedule, the train only stops at its current stop and runs through every other station. Check the spelling of the station name (case doesn't matter).
- The station it has just left is skipped until the whole train has cleared it.
- The junction must be a plain rail. Powered, detector and activator rails can't switch.
- The train must have a schedule. With no schedule it leaves junctions as they are set.
- The destination must be reachable within 4,096 rail blocks of loaded track. Further away it heads in the straight-line direction of the destination and searches again at each junction.
- It may be avoiding an oncoming train by taking the other side of a passing loop. That's intended.
- Track changes are noticed within 10 seconds.
See Coupling messages. The usual causes are: you clicked a car in the middle of the train, the coach isn't on the same track right behind the last car, or the train is moving.
Ask an operator to run /tinytrains list: it shows every train, where it is and whether it's moving, and a click
teleports there. /tinytrains stop <id> stops it, even from the other side of the map.
Use sneak + right-click with an empty hand on the locomotive (not a coach). With anything in your hand, or without sneaking, you board instead.
When getting off, you land beside your seat if there's floor and head room there. In a narrow tunnel there's no room, so you end up on the car. Leave a block of space beside the track at stations.
All seats in that car are used: 1 in the locomotive, 2 in each coach. Try another coach.
← Dynamic Lights · Home · FAQ →
Report a bug · Tiny Trains © pvvlvz, All Rights Reserved