Skip to content

Hardware_Specification_UP2_6000

Jump to bottom
Teteh Camillus Chinaedu edited this page May 5, 2022 · 8 revisions

Datasheet

SoC

Memory

  • 2GB/4GB/8GB (Max 8GB) LPDDR4/4X 3200MT/s

Graphics

  • Intel® UHD Graphics

Video Output

  • 1 Full HDMI 2.0b – 4K (3840x2160) @ 30 hz
  • 1 DisplayPort 1.2 – 4K (4096x2160) @ 60 hz
  • eDP display – 4K (4096x2160) @ 60 hz

Storage

  • 32GB eMMC / 64GB eMMC and Optional:via 1x SATA with power connection / 1x NVMe M.2 2280

Network

  • 2x GbE via (1x Intel.WGI211AT ,1x Intel.I225-V) (for Intel® Celeron® N6210, Intel® Pentium® J6426 SKUs); 2x GbE via (1x Intel.WGI210IT ,1x Intel.I225-IT) (for Intel Atom® x6413E, Intel Atom® x6425RE SKUs)

USB

  • 2x USB 3.2 Gen2 Type A (STACK connector)

SATA

  • Full-size SATA3 port (SATA 6Gb/s)

Audio

  • HDMI Audio x 1, DP Audio x 1, Soundwire Codec for Audio Out/Mic In/, I2S

Expansion Slot

  • 1x M.2 2242/2280 M Key (supports NMVe SSD)
  • 1x M.2 2230 E Key
  • 1x M.2 3042/3052 B Key

Digital I/O

The UP Squared 6000 has connectors for GPIO/peripherals:

  • HAT connector: pin-compatible with Raspberry Pi Pin position

HAT Connector

Each of the HAT pins has a dual function, a standard GPIO in/out mode, and a function mode.

On the board start, all the pin are set in function mode by default but that can be changed within the bios menu see 40-pin multi-function I/O header pinouts in Related Links below.

  • I2C

    • 3 channels (1 of 3 is in the carrier board):
    • mode supported Standard, Fast, Fast Plus, High Speed)
    • Bus frequency can be selected in BIOS settings
    • The default i2c channel is the one connected to the pin 3,5 of the hat
    • On some OSes the i2c-dev kernel module may need to be loaded manually to export the i2c device nodes

  • SPI:

    • Bus frequencies up to 10MHz are supported
    • 3 Chip-selects
    • To enable SPI device nodes the ACPI tables need to be overwritten as explained here

  • UART

    • 1 high-speed UART is available
    • Supporting baud rates up to 3686400 baud
    • Hardware flow-control signals are available on pins 11/36 (RTS/CTS)

Please note that a kernel with UP board support is required to enable the I/O interfaces above.

Refer to http://www.up-community.org for more information.

RTC

  • Present

Board Dimension

  • 101.6 mm × 101.6 mm

Power Supply Specifications

Related links

NOTE: This wiki is the main source of documentation for developers working with (or contributing to) the UP products. If this is your first time hearing about UP, we recommend starting with our main UP website, and our UP community page.

UP Wiki

Home

Boards

Community Forums

Downloads

Shop

Clone this wiki locally