Assembly | Bridge | 4 String
ℹ️ Heat Set Inserts must be inserted with a Soldering Iron.
Insert 4x M4 Heat Set Inserts into the holes on the BOTTOM of the bridge.
ℹ️ These are so that the ball-end strings are pressing against metal and not plastic so they hold their tune longer.
⚠️ Be careful to not melt the inside of the bridge too much when putting these in. Work quickly so heat doesn't build up and if you HAVE to melt one side, try to melt the side facing the back.
From the underside of the bridge, insert 1 M5 Heat Set Insert into the bridge adjustment screw hole.
⚠️ Make sure to not push the HSI out the front of the bridge.
Insert the M5x20 Screw into the Bridge Adjustment HSI
GENEROUSLY glue the Piezo mic into the bridge using super glue.
💡 I like to put a thick line down, put the mic in and then turn it side-to-side a few times to spread the glue around.
⚠️ Make sure you plan ahead for where the wire is supposed to exit the bridge for your given wing set and make sure they're going out the right hole. If you're not careful the 2020 can cut the wires.
Insert M5 Slide In nuts to the bottom of the 2020
Push the bridge onto the 2020.
💡 This is a tight fit.
Using 2 M5x30 screws, attach the bridge to the 2020.
✏️ You want this to be tight enough that it can't slide up and down but loose enough that the bridge can still be rotated.