-
Notifications
You must be signed in to change notification settings - Fork 1
AD469x Platform FPGA Architecture SPI Engine SPI Bus Interface
The SPI bus interface carries logical low-level SPI bus signals.
Name | Description |
---|---|
spi_master_rtl.xml | Interface definition file |
Name | Direction (Master) | Description |
---|---|---|
sclk | Output | SPI Clock. |
sdo | Output | SPI SDO (MOSI) signal. |
sdo_t | Output | sdo tri-state enable. If 1 the MOSI signal should be tristated and not be connected to sdo |
sdi | Input | SPI SDI (MISO) signal. Execution module supports max 8 individual sdi lines. |
cs | Output | SPI chip-select signal. |
three_wire | Output | If set to 1 the bus should operate in three-wire mode. In three-wire mode sdi is connected to MOSI instead of MISO. |
![](https://github.com/ArrowElectronics/data-storm-daq/raw/master/images/spi_bus.png)
The SPI bus interface only carries a logical representation of the low-level SPI bus signals. The top-level module in the FPGA design project is responsible for translating the signal to physical SPI bus signals by instantiating and connecting it to appropriate IO primitives.
The sclk and cs signals can typically be directly connected to a output buffer. sdi should be connected to a mux, that depending on the setting of the three_wire signal connects to a input buffer connected to the miso signal or to a input buffer connected to the mosi signal. The sdo signal should be connected to a output tri-state buffer with the sdo_t signal controlling the tri-state setting.
In some configurations three-wire support may not be required and sdi can directly be connected to the input buffer for the miso signal. Similarly when mosi tri-stating is not required the sdo signal can be directly connected to the mosi signal leaving the sdo_t signal unconnected.
The following example Verilog code shows the most generic IO configuration, which represents the diagram above. Depending on system requirements some simplification might be possible.
Signals with phy prefix are assumed to be connected to the physical input/output pins and signals with the spi prefix are assumed to be connected SPI-Engine bus interface.
assign phy_sclk = spi_sclk;
assign phy_cs = spi_cs;
assign phy_mosi = spi_sdo_t ? 1'bz : spi_sdo;
assign spi_sdi = spi_three_wire ? phy_mosi : phy_miso;
NOTE: In the HDL design for AD469x we have configured SPI Engine SPI Bus for 1xSDI input lines from ADC to FPGA .
Back to SPI Engine Framework Architecture
Please click Here to purchase platform boards
Arrow Data Storm DAQ Development Platform
Introduction
Developer Starter Guides
Additional Developer Docs
AD40xx Platform User Guide
AD7768 Platform User Guide
AD7768-1 Platform User Guide
AD7606B Platform User Guide
AD738x Platform User Guide
AD469x Platform User Guide
AD463x Platform User Guide
ADRV9001/2 Platform User Guide