Repository navigation
Calibration Guide
NebulaOS edited this page Nov 6, 2026
·
5 revisions
This page has moved: First calibration (the short path) and Calibration explained (every routine).
All calibrations are now on one page, one section each. Start from what you see on the print in Improve your prints.
1. Get printing
- 1. What is NebulaOS
- 2. Install NebulaOS
- 3. First start
- 4. First calibration
- 5. Set up your slicer
- 6. Your first print
- 7. Keeping NebulaOS updated
2. Improve your prints
3. Using NebulaScreen
- Overview
- Home and printing
- Macros and Console
- Tune
- Settings → Connections
- Settings → Display
- Settings → Printer
- Settings → System
- Settings → Updates
- Settings → Reset
- Camera
- Timelapse
- Power-loss recovery
4. Advanced and integrations
- SSH, SFTP and security
- Files, configuration and backups
- Mainsail and Moonraker
- Custom macros and integrations
- Beeps and songs
- How NebulaOS works
- Two system slots
- Other printers (community boards)
- Words you will see
- Thank you
5. Help and recovery
- Troubleshooting
- Report a problem
- Going back to stock
- Resetting
- Mainboard firmware
- Recovery (when it will not start)
Developer documentation lives in each component repository. Start from the project README.