Repository navigation
Troubleshooting
- Right-click a post and read Overview. If it reports no compatible emitter in range, check the layout before changing filters. Put the bases on the same north/south or east/west line, up to 20 blocks apart. Both ends need to be loaded and have compatible ownership.
- If the field reports no energy, attach a generator or charged cell. Stored must cover at least one tick of Needs. Check the output side of the cell.
- Check Enabled and Turn on. For a simple test use On and Always (while powered). A redstone signal supplies no energy.
- If the status says Field running, look under Appearance → Display options → Show forcefield. An invisible field can still block you.
For a short layout with an exact energy cost, see Build your first field.
Check for a sudden rise or drop of more than four blocks between neighboring columns. Try stepping the terrain or placing an intermediate post on a landing. A diagonal line between two posts cannot form a wall.
Mount the rails on opposite vertical faces at the same height. Click Connections → Bridge mode and let it finish forming before stepping on. Choosing Horizontal floor / ceiling sets only the shape. If you edited the blocking filter afterward, check Players, downward movement and Skip owner: No. Also check that the power supply can sustain the bridge. Bridge layout
Under Sensor, set Detection to Pulse on crossing, select your target and allow it through Blocking. Test by walking completely through the plane. If you own the field, check Skip owner on the Sensor tab. For a post wall, wire the Output side of the post whose Connections page lists the other end under Field to. For rails, use the Redstone output at coordinates. Several quick crossings extend one pulse. The crossing counter can increase while the lamp is already lit. Sensor setup
Check Blocking → Skip owner and any Always allow or Always block entries. Open Connections and see whether the affected link has its own rules. Check Travel directions too. If the friend has a passage card, make sure the field owner issued it and the field accepts its group. Access cards
Use Access → Inventory checkpoint. Switch it on, list the item under Contraband item list, then select an action under When contraband is found. For a test, put the item in a normal inventory slot and set Skip owner to No under Players & directions. A dropped-item rule on Blocking or Sensor won't inspect your pockets. Checkpoint setup
Check Overview again. A large shell costs more energy, needs more loaded chunks and has to fit within world height. A full sphere also needs room below the base. Reduce the radius to test the original setup. Domes and spheres
Check that you are in the same dimension and the field is loaded. The owner can invite managers under Access → Field management. Having a passage card alone won't let you edit the field. If the controls show a locked preset, ask a server operator about that preset. Field Tuner
If the problem persists, include your Minecraft version, loader, Field Emitters version, the smallest build that shows it, and what happened. For a rail or wiring problem, include a picture showing both ends and where the energy or redstone connects. Report an issue
Getting started
Builds
Tuner guides
- Using the Field Tuner
- Blocking filters
- Sensors and redstone
- Access cards and permissions
- Inventory checkpoints
- Contact damage
- Appearance and sounds
Reference