Baud Rate Test

Note

Because BobTerm's RX buffer is very small, higher baud rates are not stable. This test uses ICE-T, which has a much larger RX buffer.

For this test, you will need

• Atari
• FujiNet
• WiFi Connection
• Host slot defined: atari-apps.irata.online

Steps

1. Power on #FujiNet
2. Power on Atari
3. Wait for CONFIG to boot.
4. Ensure atari-apps.irata.online is in a host slot.
5. Select Atari-apps.irata.online
6. Select Comms
7. Select modem-programs.atr
8. Select D1:
9. Select R/O
10. Verify that modem-programs.atr is mounted as R in D1:
11. Press [OPTION] to boot. Hold option if needed.
12. Wait for Disk Directory menu.
13. If using a system with less than 128K of RAM, select ICET800.COM, otherwise, select ICETXE.COM.
14. Wait for ICE-T to load.
15. Once loaded, TERMINAL is selected in the menu, press [RETURN], twice. The terminal is now at 300 baud.
16. Once the blinking cursor appears, type AT? and press [RETURN]
17. The FujiNet Virtual Modem 850 help text, should appear.
18. wait for OK.
19. Press `[Shift-ESC to return to menu.
20. Use right arrow key to move to Settings, and press [RETURN] and Settings drop-down menu should appear. Baud Rate should be selected. Press [RETURN]
21. A submenu of baud rates should appear. Use the down arrow to move to the 19K setting, and press [RETURN] to select. You should hear audio confirmation from POKEY that the baud rate command was sent to FujiNet.
22. The Baud rate menu should re-appear. Press [ESC] to close the menu.
23. Press left arrow until Terminal is selected. Press [RETURN] to select it.
24. Once terminal cursor re-appears. type AT[RETURN].
25. If ERROR appears. This is okay. Type AT[RETURN] again.
26. Once OK appears, Type AT?[RETURN]
27. The HELP screen should appear, much faster now, since it is transmitted at 19200 baud, and since ICE-T has a large enough RX buffer, all characters should appear, without problem.
28. Test done. Power off Atari.

Expected Result

FujiNet should immediately respond to baud rate changes without user intervention.