Skip to content

Filter AGC and noise reduction

SP5XTF edited this page Nov 8, 2026 · 2 revisions

Filter, AGC and noise reduction

Wersja polska

RX DSP / Filter (left column)

  • The graph shows the passband in the 0–4 kHz audio range: trapezoid = width and SHIFT, red notch = NOTCH, amber dip = CONTOUR, DNF marker.
  • RX BW – filter width (the index reported by the radio is shown next to it). In AM/FM the width is fixed.
  • SHIFT – passband shift (20 Hz steps), the 0 button resets it.
  • NOTCH (manual) with frequency, DNF (automatic notch), CONTOUR with frequency.
  • AGC: FAST / MID / SLOW / AUTO.

Right column

  • AF, SQL, RF – volume, squelch, RF gain; TX – transmitter power.
  • IPO / AMP1 / AMP2 – preamplifier, ATT – attenuator.
  • DNR, NB, PROC – as on the radio: the button turns it on and off, the slider next to it (the knob equivalent) changes the level remembered in the radio – also while the function is off (slider dimmed); turning it back on returns to that level.
  • MIC, AMC – microphone gain and automatic power control.

Settings are read from the radio after connecting and about every 3 s, so changes made with the radio's knobs show up too. A greyed-out control = the radio did not answer its command (listed in the Help → CAT log window, ⌥⌘L).

  • NAR – the radio's narrow filter (button in the “RX DSP / Filter” box, next to NOTCH, DNF and CONTOUR; also in the remote panel, Filter section). RX BW then switches to the radio's narrow range. DNR – the radio's digital noise reduction (right column: on/off and level 1–15; in the remote panel – Receive section).

← VFO and tuning · Home · Transmitting and safety →

Clone this wiki locally