Skip to content

RF scope and waterfall

SP5XTF edited this page Nov 3, 2026 · 1 revision

RF scope and waterfall

Wersja polska

The scope shows the same data as the radio's display, read through the built-in FTDI FT4222 bridge.

Requirements (once)

  1. On the radio: MENU → OPERATION SETTING → GENERAL → SCU-LAN10 = ON, then unplug and replug the USB cable. “USB diagnostics” must show 0403:601C FT4222.
  2. FTDI libraries in /usr/local/lib: libft4222 (“LibFT4222 for Mac” package) and libftd2xx (D2XX for macOS) – details in the README.
  3. Only one program at a time can read the scope.

Using it

  • On – start/stop reading. Span and CENTER/FIX mode are set on the radio.
  • Red line = VFO-A; hovering shows the frequency, clicking tunes VFO-A.
  • Auto sets the floor to the noise level; Contrast and waterfall speed are in the scope bar.
  • Call signs above the spectrum line are DX Cluster spots and POTA activations (rows chosen so they do not overlap). Label background as the FT8 colours, the DXCC column and alerts: cyan – watched call, magenta – new entity, light pink – new entity on band, purple – unconfirmed entity, light purple – unconfirmed on band, amber – none of these. POTA has a green line and a green outline (tooltip: park and its name; the same call in the cluster and POTA is shown as POTA). Clicking a call or its line tunes the radio exactly to the station, puts the call (for POTA also the park) in the logbook form and opens the LOG tab; clicking another station replaces the call. Turning off: DISPLAY tab → Stations on the scope.
  • Scrolling: drag the spectrum left/right with the mouse, swipe sideways with two fingers on a trackpad, or use Shift + mouse wheel. The plain wheel over the scope tunes the radio by the STEP (like the VFO knob). In CENTER mode the radio keeps the VFO in the middle of the scope, so scrolling retunes the VFO and the picture follows; in FIX mode the scope range stays put and only the VFO changes.
  • Save frames saves raw frames to the Desktop (for diagnosis), Log – the FT4222 connection log.
  • Connection recovery: when the scope loses sync with the radio (USB interference, long operation), the program reconnects by itself – with no attempt limit while the scope is on: intervals of 1, 2, 5, 10, then every 30 s, and every third attempt is a hardware reset of the FT4222 chip (the scope equivalent of restarting the radio). The state shows in the scope header; details – the Log button. Restarting the radio should no longer be needed.

← Transmitting and safety · Home · Display – colours and 3D mode →

Clone this wiki locally