Skip to content

Transmitting and safety

SP5XTF edited this page Nov 3, 2026 · 1 revision

Transmitting and safety

Wersja polska

Transmitting from the app is deliberately protected – all controls are in the block at the bottom of the right column.

  • Enable TX – without this consent PTT, TUNE and messages are inactive. Turning it off always ends transmission.
  • Time limit (1 / 3 / 5 min) – on the RX/TX tile next to the meters: “TX limit: 3 min” while receiving, and while transmitting the time and the limit, e.g. “0:42 / 3:00” (the last 30 s in orange). When it expires the app sends TX0 itself and locks PTT until the button is released. It covers PTT from the app, radio memory messages and TUNE (not the hand microphone at the radio).
  • PTT – transmits only while the button is held with the mouse.
  • TUNE – ON/OFF switches the tuner, the TUNE button starts tuning (the radio transmits a carrier).
  • Messages (CQ, Call, …) – play messages recorded in the radio's memory (voice in SSB/AM/FM, CW in CW). Button label: right-click → “Edit label…”. STOP stops the message and ends transmission.

TX0 is always sent: on disconnect, when closing the window or the program (also Ctrl+C in Terminal), when consent is turned off, when the limit expires.

SSTV, CW and RTTY: the length of an SSTV image and of CW and RTTY text is checked against the limit before sending; SSTV and RTTY stop when the radio stops transmitting, and withdrawing consent or disconnecting the radio stops them whichever tab is open. CW is keyed with the DTR/RTS line of the radio's second port – bypassing the CAT time watchdog – so STOP, withdrawing TX consent or disconnecting the radio releases the key immediately, whichever tab is open.

Make your first transmit tests into a dummy load at low power, watching ALC and SWR.


← Filter, AGC and noise reduction · Home · RF scope and waterfall →

Clone this wiki locally