Skip to content

RTTY decoder and sending

SP5XTF edited this page Nov 3, 2026 · 1 revision

RTTY – decoder and sending

Wersja polska

The RTTY tab: radioteletype (Baudot ITA2, standard 45.45 baud, 170 Hz shift).

Band buttons (tuning panel, 160–10 m): the radio in DATA-L, set 2.125 kHz above the centre of RTTY activity (e.g. 14.085, 7.040, 3.590 MHz), so signals land on the 2125 Hz mark tone. The program remembers the last RTTY frequency on each band; right-click – back to the default. Changing band stops transmitting.

Receive

  • Needs monitoring on. The radio can be in DATA-L or RTTY-L (mark 2125 Hz).
  • AFC finds the tone pair and tunes to a fraction of a hertz; you can also click the station's mark tone in the spectrum. On the spectrum: M – mark, S – space.
  • The decoder prints only when an RTTY tone pair is in the spectrum – silent on voice and noise; the start of a transmission is not lost (the last 1.5 s are replayed).
  • Reverse by radio mode: in DATA-L/RTTY-L the mark is the lower tone, in DATA-U/USB the higher one; the program sets this itself (you can turn it off and use REV).
  • USOS – back to letters after a space (standard).
  • Measured on test recordings: SNR 10 dB – 0 % errors, 5 dB – 2 %, 40 Hz off-tune – 3 %, noise only – no false characters.

Transmit (AFSK)

  • Radio in DATA-L (the Set radio: DATA-L button), audio over USB – the “To radio (TX)” device in the AUDIO tab.
  • The program transmits on the tones it receives – once tuned to a station you reply on its frequency.
  • Macros ({CALL} = your call), text, Level – set so that ALC barely moves. RTTY is a continuous carrier: reduce power.
  • Requires Enable TX; the text duration is checked against the transmit limit; STOP, withdrawing consent or disconnecting the radio ends transmission.

Log (column on the right)

  • Call with a QRZ/HamQTH lookup (name, QTH and locator fill in themselves; for a station away from home only the name), entity and “new station” or “worked: N QSOs”.
  • RST sent and received – empty fields are saved as 599.
  • Log QSO (or ⌘↩) – RTTY mode, frequency from the radio, saved as in the program's log (entity, zones, distance, upload to services).

← Propagation · Home · FT8 and FT4 →

Clone this wiki locally