Repository navigation
Tools SWR sweep and who hears me
SP5XTF edited this page Nov 8, 2026
·
1 revision
Antenna SWR sweep (menu Window → Antenna SWR measurement…, ⌥⌘S)
- The program steps through the band (5–51 points) and on each frequency sends a short carrier (a 1500 Hz tone in DATA-U over USB audio, about 0.5 s) at low power (5–10 W), reads the SWR from the radio and draws an SWR curve with the minimum marked and lines at 1.5 and 2.0. Hovering over the chart shows the frequency and SWR of the nearest point.
- Requires Enable TX, a radio connection, the “To radio (TX)” device and DATA modulation source = USB in the radio menu. A confirmation appears first – listen whether the frequencies are clear.
- Safety: amateur bands only; stops at SWR > 5, when there is no output power, with the STOP button, when the radio disconnects or “Enable TX” is withdrawn. The frequency changes only while receiving. Tuner off (default) – you measure the antenna itself. Afterwards the frequency, mode, power and tuner state return.
- Carrier test (3 s) – one carrier in the middle of the band with live power and SWR readings: a check before measuring. When the power is zero, the message says whether the radio transmitted at all and what the reading was – usually the DATA modulation source in the radio menu (it must be USB/REAR) or a too quiet tone is to blame: the Tone level slider (like “TX level” in FT8) and the volume of the “To radio (TX)” device in macOS.
- Measurements are saved (list on the right); right click: compare with the selected one (grey line – e.g. before and after adjusting the antenna), CSV, delete.
Who hears me (menu Window → Who hears me…, ⌥⌘K)
- A map of stations that received your signal (FT8, FT4, PSK, JS8…) according to PSKReporter.info – point and line colour = band, red point = your station (locator from the Station profile).
- Night and the day/night line: the dark side of the map is night, the orange line – the terminator (grayline), along which DX paths often open on the lower bands; refreshed every minute.
- Period (15 min, 1 h, 6 h, 24 h) and band – switching is immediate (the last 24 h is fetched). Summary: number of receivers, the farthest, on the night side, counts per band; the receiver list from the farthest (hover – locator, mode, time).
- PSKReporter asks for queries at most every 5 minutes – the program keeps to this (the every 5 min option refreshes by itself). Reports appear when receivers send them to PSKReporter (e.g. WSJT-X), usually with a few minutes' delay.
Generated from the built-in help of FT-710 Control 0.9.6-beta – do not edit here; changes go into the program (Help.swift) and tools/make_wiki.py. · Wygenerowane z pomocy programu – nie edytuj tutaj.
English
- Getting started
- Station profile
- VFO and tuning
- Filter, AGC and noise reduction
- Transmitting and safety
- RF scope and waterfall
- Display – colours and 3D mode
- Logbook, QRZ.com and map
- Online services (LoTW, QRZ, eQSL, WRL…)
- DX Cluster
- SSTV – images
- CW – decoder and sending
- Propagation
- RTTY – decoder and sending
- FT8 and FT4
- PSK31 and PSK63
- Tools: SWR sweep and who hears me
- POTA – Parks on the Air
- Alerts
- Contests – scoring and Cabrillo
- CAT Share (WSJT-X, JTDX)
- USB audio
- Remote operation
- Diagnostics
- Shortcuts
- Troubleshooting
- About
Po polsku
- Pierwsze kroki
- Profil stacji
- VFO i strojenie
- Filtr, AGC i redukcja szumów
- Nadawanie i bezpieczeństwo
- Skop RF i waterfall
- Ekran – kolory i tryb 3D
- Dziennik, QRZ.com i mapa
- Usługi online (LoTW, QRZ, eQSL, WRL…)
- DX Cluster
- SSTV – obrazy
- CW – dekoder i nadawanie
- Propagacja
- RTTY – dekoder i nadawanie
- FT8 i FT4
- PSK31 i PSK63
- Narzędzia: pomiar SWR i kto mnie słyszy
- POTA – Parki w eterze
- Alerty
- Zawody – punktacja i Cabrillo
- CAT Share (WSJT-X, JTDX)
- Audio USB
- Praca zdalna
- Diagnostyka
- Skróty
- Rozwiązywanie problemów
- O programie