FC200 Live View Encoder board
Function
Variants
Parts
Programming
External interfaces
Service interfaces
Board view
Schematics
The Live View encoder board is responsible for preparing digital video signal for live FPV feed. It encodes the video and sends the stream to WiFi board.
The board contains DM3xx series media processor which does the encoding and controls input and output lines. All other components on the board are just supplemental chips required by DM3xx to work.
Known versions of the board are shown below.
| Marking | Overview |
|---|---|
| P00033.V1 |
| Marking | Amt. | Pkg. | Function | Specification |
|---|---|---|---|---|
| TODO | DM3xx Media Processor | |||
| TODO | RAM from DM3xx, IS43DR? | |||
| TODO | NAND for DM3xx, MX30LF1G/MT29F1G? |
| Chips | Firmware | Description |
|---|---|---|
| DM3xx, IS43DR?, MX30LF1G/MT29F1G? | m0800 | Live feed video encoding. |
| Marking | Overview |
|---|---|
| TODO |
The following service pads exist on this board:
| Marking | Overview |
|---|---|
| TP1 | UART_TX; 3.3V UART of DM3xx chip, Transmit line; allows access to UBoot and DaVinci Linux console |
| TP2 | UART_RX; 3.3V UART of DM3xx chip, Receive line |
| TP3 | GND; Ground, connected connected to all other ground pads |
| TP4 | 1.2V power for the DM3xx chip |
| TP5 | 5V |
| TP6 | |
| TP7 | 1.8V power for the DM3xx chip |
| TP8 | 3V(power) |
| TP10 | 3.3V |
| FD1 | |
| BSEL | Boot Select pin of DM3xx chip does not exist as service pad, but is accessible at a specific resistor on the board (middle one in three parallel resistors - you can figure out details using the photo with chip de-soldered) |
Top of an unknown P00033 board:
Bottom of the P00033 board, with DM3xx chip de-soldered:
Top of another P00033.V1 board:
Bottom of the P00033.V1 board:
No schematics available.