P330 Receiver board
Function
Variants
Parts
Programming
External interfaces
Service interfaces
Board view
Schematics
The board receiver RF signals from the Remote Controller, and prepares packets for Flight Controller based on them. Compared to first Phantom, the receiver has been switched to double channel. This increased reliability of the radio link.
The receiver used should work on a different frequency band than FPV transmission.
There are multiple versions of the board.
| Marking | Overview |
|---|---|
| WM300 2.4G TX RF V1 | The "TX" in marking looks like a mistake. |
| Phantom 2.4G RF V3 | |
| Phantom 2.4G RX RF V4 | |
| Phantom II 5.8G TX RF V3 | Again, "TX" marking is inaccurate. |
| Phantom II 5.8G RX RF V5 |
| Marking | Amt. | Pkg. | Function | Specification |
|---|---|---|---|---|
| TODO | 1 |
| Chips | Firmware | Description |
|---|---|---|
| TODO |
Connectors on the board are:
| Marking | Overview |
|---|---|
| TODO |
The following service pads exist on this board:
| Marking | Overview |
|---|---|
| TODO |
Top of a "2.4G TX RF V1" board:
Top of a "2.4G RF V3" board:
Top of a "2.4G RX RF V4" board:
Bottom of the "2.4G RX RF V4" board:
Top of a "5.8G TX RF V3" board:
Bottom of the "5.8G TX RF V3" board:
Top of a "5.8G RX RF V5" board:
Bottom of the "5.8G RX RF V5" board:
Top of another "5.8G RX RF V5" board:
Bottom of the "5.8G RX RF V5" board:
No schematics available.