DFRobot_Digital_Vibration_Sensor_V2_SKU_DFR0027

Digital Vibration Sensor V2

Introduction

What's the simplest way to check vibration with Arduino? Use a vibration sensor from DFRobot. You can directly plug it on our IO Expesion Shield V7. Just vibrate this sensor, Arduino can receive a digital signal. It's easy to acount and program in Arduino.

Despite it's simple, you can make full use of it with creative thinking, like step counting, Crash warning light and so on.

Specification

Wide voltage range from 3.3V to 5V
Standard assembling structure (two 3mm diameter holes with multiple of 5mm as distance from center)
Easily recognitive interfaces of sensors ("A" for analog and "D" for digital)
Icons to simplely illustrate sensor function
High quality connector
Immersion gold surface

IO Type: Digital
Switch life: up to 10 million seconds
Open circuit resistance: 10Mohm
Supply Voltage: 3.3V to 5V
Interface: Digital
Size:22x30mm

Tutorial

Connection Diagram

connection diagram

Sample Code

#define SensorLED   13
//Connect the sensor to digital Pin 3 which is Interrupts 1.
#define SensorINPUT  3�
 �
unsigned char state = 0;
 �
void setup() {
  pinMode(SensorLED, OUTPUT);
  pinMode(SensorINPUT, INPUT);
  //Trigger the blink function when the falling edge is detected
  attachInterrupt(1, blink, FALLING);
}

void loop() {
  if (state != 0) {
    state = 0;
    digitalWrite(SensorLED, HIGH);
    delay(500);
  }�
  else
    digitalWrite(SensorLED, LOW);
}
 �
//Interrupts function �
void blink() {
    state++;
}